1st gen wheel spacers

J

jjohnston10

New member
Anyone know where I can find 1/8 inch wheel spacers for my ITA RX-7? It seems that they are available for most other cars but not the RX-7.
 
If you race in the SEdiv (SCCA) the track vendor almost always has these available in 1/4 inch thickness-------I'm not sure if I have ever seen 1/8 inch spacers----at one point I had my machine shop make some 1/2 inch spacers----1/8 inch would be easy to fabricate
 
i need some quarters are they available online anywhere?

------------------
Daryl Brightwell
ITA RX7#90
San Francisco region
Cal Club
 
Here are a couple of sources:

http://www.hrsprings.com/index.html

http://www.pdm-racing.com/products/misc_parts.html

The H&R Springs spacers are pretty Hi-Tech. The PDM Racing units are just your standard spacers. The price may dictate which ones you decide on...

Good luck
biggrin.gif
 
HEY BANZ, is your 240 rear wheel drive?
there are none running out here.
 
Originally posted by 7'sRracing:
HEY BANZ, is your 240 rear wheel drive?
there are none running out here.
Click to expand...

Yep, just where the drive wheels should be! I haven't been able to race at all this year, due to new babies and too much work, but next year, the '97 should be homoligated into ITS, as the '95/'96 were this year, so my plans are to hit it fairly hard next season. The car is sitting in the garage in Speedvision WC trim right now, so I need to remove the passenger side-bars and replace them with straight bars, put a standard (non-gutted) passenger door back on, and swap the motor for an IT motor to have it ITS legal. I should be able to get that done in short order this winter...

If all goes well, I'll be racing it in Radial Sedan with our Local ICSCC club race on October 6/7 at SIR.

Where is "out here"?
smile.gif
 
You must log in or register to reply here.
Back
Top