Backing Plates w/ duct fitting

J

JeffW

New member
I saw a backing plate that was fitted with a duct fitting that faced the front of the car (1st Gen RX7). Nice, solid 90 degree bend that directed air perpendicular to the rotor. Looked like it would save me from stuffing extra hose in there that always seems to get in the way. The only problem now is that I can't remember where I saw it.

Anybody seen and used this one?

Jeff
 
If you can weld, you can make your own. The first side took me about 2 hours to figure out. 2nd side was under 45 minutes.

Stick with under 3" ducts and you'll have plenty of room.

------------------
Scott Rhea
It's not what you build...
it's how you build it

Izzy's Custom Cages
 
You must log in or register to reply here.
Back
Top