Brake duct

jmracer17

jmracer17

New member
Where is a good spot to mount the end of the hose to blow on the rotor? I have the fronts ok but am unsure where the best spot to mount the rest. Thanks.
 
Cram it down into the triangle formed by the upright, and the caliper, pointing at the center of the rotor/bearing. Safety wire in place.

Figure out the routing before cutting it, to leave enough lenght for tire clearance when turning.
 
turn wheels all the way left for the right duct and right for the left duct to make sure you have enough clearanc3

displayimage.php
 
Here's what we use. These are fiberglass and blow into the center of the ventilated disk, and also just above the outside of the disk. Hose runs above control arm and below drive shaft. Not a lot of wasted air and hi velocity. 2.5" hose. Also blows on wheel bearing too.


http://i17.photobucket.com/albums/b56/loopracing/IMG_0605.jpg

http://i17.photobucket.com/albums/b56/loopracing/IMG_0609.jpg

http://i17.photobucket.com/albums/b56/loopracing/IMG_0618.jpg

http://i17.photobucket.com/albums/b56/loopracing/IMG_0607.jpg

http://i17.photobucket.com/albums/b56/loopracing/IMG_0606.jpg
 
Those are really nice..
Put a price on them, and get on with paying for your racing.
The Cup ones are tig welded and cost about 80$ ea. used.
MM
 
After this weekend at Blackhawk, I'll get around to making a batch of them. I can do fiberglass in most colors and carbon fiber ones for a bit more. I've sold them for $100 a pair with mounting brackets. And $50 more for Carbon fiber if anyone's interested. May take a couple weeks though, racing season's just starting here.
 
One other note, they are specific to each side. They fit right along the steering knuckle. Refer to the above links, and maybe you can get an idea if they would fit or be modified.
 
I want for MK3! There are two cars here in DC that would buy them instantly. We could even send you a spare knuckle for development.
 
Last edited:
I would be interested, I'd need a knuckle/disk/hub probably from each side. possibly the A1 mold i have may be easily modified, which could save time. Email me if interested. may take a month or so...racing season is on now.
 
Will these will work for the 10.1" rotors?

I'd like a set in carbon fiber please, and it would be for a scirocco II.

John
 
You must log in or register to reply here.
Back
Top