Terry222TT
New member
Hey guys, I'm putting the finishing touches on a ITS RX-7. I need some suggested settings to get started. Once I get those I can take it from there.
Thanks for the Advice, Terry
Thanks for the Advice, Terry
Good Starting Setting for Camber, Toe-in etc.
- Thread starter Terry222TT
- Start date
Eagle7
New member
I'm no expert, but I'll start. It certainly depends on your suspension components and tires, which you might want to post.
I've got 500/375 springs, a Suspension Techniques front bar set on soft, no rear bar, and run Hoosier R3S04.
Front - 3 deg camber, 0 toe on fast tracks, 1/16" toe out on twisty tracks.
Rear - 2.1 deg camber (can't get any more without changing the exhaust - but it seems OK), 1/8" toe in. I usually put 2 PSI extra in the rear tires to loosen it up a little.
------------------
Marty Doane
ITS RX-7 #13
CenDiv WMR
I've got 500/375 springs, a Suspension Techniques front bar set on soft, no rear bar, and run Hoosier R3S04.
Front - 3 deg camber, 0 toe on fast tracks, 1/16" toe out on twisty tracks.
Rear - 2.1 deg camber (can't get any more without changing the exhaust - but it seems OK), 1/8" toe in. I usually put 2 PSI extra in the rear tires to loosen it up a little.
------------------
Marty Doane
ITS RX-7 #13
CenDiv WMR
Terry222TT
New member
Marty,
Thanks for the answer. That's what I'm looking for. I'm waiting on a set of Zeals and will be running Toyo RA1s. I'll have to check on the spring rates.
thanks, Terry
Thanks for the answer. That's what I'm looking for. I'm waiting on a set of Zeals and will be running Toyo RA1s. I'll have to check on the spring rates.
thanks, Terry