Header & Exhaust - 2nd gen RX-7 ITS ??

B

Bern

New member
Guys,
What system are you 2nd gen guys using?

We are debating between a specialized IT header and single path exhaust or a RB dual header with duals all the way out to a single muffler.

Just looking for general experiences and advice.

-Bern
 
RB Street header (2 into one) and a 2.5" single exit pipe to a Magnaflow muffler.

Power hasn't been an issue yet, but still not dynoed to see if I could do better.

PaulC
 
I just installed the ISC Setup. I used a Racing Beat Dual header. ISC supplies a 2into1 collector/expansion chamber. Then a 3" pipe from the front section and a Dynomax 3" straight through muffler. It is supposed to make 6-10 more HP that the next leading brand. I have a pre dyno chart, so I will be able to make a post dyno comparison.

The whole setup (w/headers) was just about $650 with shipping and clamps/hangers.

------------------
Paul D'Angelo
73 ITS CENDIV
Indy Region
www.iridiumracing.com
 
I'm running a RB race header to (2) 2 1/4" tubes going into a 3" collector and exiting out a Dynomax muffler w/ adjustable 90* tip. Sorry, no dyno numbers
 
Went FROM a RB header and custom single 3" into an Ultra Flow (the muffler ISC uses as well) to the complete ISC system and saw a 5 hp gain - dyno proven.

The system is a little rough, may need a couple of SMALL tweaks but I highly recommend it.

AB

------------------
Andy Bettencourt
06 ITS RX-7
FlatOut Motorsports
New England Region
www.flatout-motorsports.com
 
If you do have a RB header, or any other for that matter, and want it to last, get it Jet-hot coated. They have a special black high temp coating used for the areospace industry that can take the heat from a rotary. My header is 6 years old and looks like the day I put it on, no rust or cracks, it's perfect. They will even do your whole exhaust if you want, inside and out. They charge by the foot.
 
You must log in or register to reply here.
Back
Top