part cleaning

C

Campbell

New member
I am tearing down a donor motor that has been sitting for a couple years in the corner of the garage - I am going to have the block bored out and re-do the head. Is there a way to clean up the gunky and dark brown stained parts besides sandblasting? any special tricks to getting things cleaned and degreased? thanks
 
Go to your local transmission shop with your aluminum parts and beg them to put them through their degreaser...works great! Chuck
 
Go to your local dollar store and buy some oven cleaner. Works great to remove the caked on grease and will even lift the tar and goo off rubber parts without damage. Best no scrub cleaneer you will ever use. Follow with a good purple or similar cleaner to remove the residue. Cashier looks at me like I'm crazy when I buy it by the case. :rolleyes:
 
Don't ever sand blast.

You can use the various cleaners described above, but if it is that "gunky," pay to have the block cleaned by the shop that will be doing the heavy work (boring. honing). They will either have a hot tank (not likely any more), an oven or high pressure system, but any of the methods get the block clean.

Cheers.
 
You must log in or register to reply here.
Back
Top