Warning Light sending units

S

Sandro

New member
Busy wiring my dash and I would like to have a Warning light for water and oil temp when they reach a certain temperature. Longacre and other companies sell these for NPT threads but I am unable to find anyone that has them in metric. I could get a larger NPT one and just retap the threads in the mounting location but Im sure someone makes them in metric. Anyone know where I could find them???

Thanks
 
only problem is those adapters have a very small through hole, and the sender has the part that needs to go through

1005.JPG


I would need one that looks like this.
3257.JPG
 
thats where I bought all my gauges from and other senders but they only have the ones for warning lights in NPT :bash_1_:
 
I don't know if you have the same issue I had, but I know I screwed up a fitting just like that blue one you posted. On my toyota, I thought the threads were metric, but they were actually npt, the difference was that the tap was not run in very far at the factory. I just purchased a npt tap and ran it in a good bit further and then the water temp sending unit fit perfectly.
 
Dave,

thanks, those will work. Dont know how I missed them.


Gt240sx,

Im going to try that on an old housing I have before I buy the above items.`

Thanks guys !
 
You must log in or register to reply here.
Back
Top